I've been triying to configure a cisco 857 router to be in bridge mode that will allow my ASA to dial the PPPoE connection. However I can't seem to get my config to work. I've tied a few veriasions to get it to work but no success. Could somboddy have a look at my config and tell me where i'm going wrong?
I get the following error when i connect to the console.
*Dec 27 11:56:46.660: %TBRIDGE-4-NOVCFLOOD: No VC's configured for bridging on ATM0
Replace the encapsulation aal5mux ppp dialer in your PVC 0/38 with encapsulation aal5snap and try again. You may also need to add the protocol bridge broadcast along with the encapsulation command on that PVC.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.