10-10-2013 08:32 AM - edited 03-04-2019 09:16 PM
I am trying to configur a cisco 857 router and experienced problems with the config of the interface fastethernet ip address.
Can someone please help-me?
"R2(config)#int fastether0
R2(config-if)#ip address 192.168.1.251 255.255.255.0
% IP addresses may not be configured on L2 links.
R2(config-if)#"
Thanks in advance
Pedro
Solved! Go to Solution.
10-10-2013 11:20 PM
Hi,
I suppose you connect your internal machine on fa0 then do this:
int vlan 1
ip add 192.168.1.251 255.255.255.0
Regards
Alain
Don't forget to rate helpful posts.
10-11-2013 04:32 AM
Hi,
Because this is a Layer 2 interface(switchport) not a Layer 3 interface and you can't assign an IP to a L2 interface.
Regards
Alain
Don't forget to rate helpful posts.
10-10-2013 11:20 PM
Hi,
I suppose you connect your internal machine on fa0 then do this:
int vlan 1
ip add 192.168.1.251 255.255.255.0
Regards
Alain
Don't forget to rate helpful posts.
10-11-2013 04:00 AM
Hi
I did nothing on this..."connect your internal machine on fa0"
I allready done
"int vlan 1
ip add 192.168.1.251 255.255.255.0" and OK.
but my question is why it do not let me configur fa0.
Regards
pedro
10-11-2013 04:32 AM
Hi,
Because this is a Layer 2 interface(switchport) not a Layer 3 interface and you can't assign an IP to a L2 interface.
Regards
Alain
Don't forget to rate helpful posts.
10-11-2013 06:19 AM
Ok, thanks
pedro
10-24-2016 02:01 AM
Hi,
Good day,
I am trying to connect my c3650 layer 3 switch to the internet via cisco 891-k9 router, the problem is my vlans (2-12) on my layer 3 switch cannot pass through the internet. i have configured one the LAN ports of my router to trunk mode and my layer 3 switch but still not working. but if i connect to the port on my layer 3 switch with no vlan assigned i have no problem connecting to the internet.
Pls. help.
Thanks,
Rolf
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: