Is it possible on a Cisco 867 to configre each port individualy, or only by using Vlan's? Everytime I try to assign a IP to an individual port I get the message: 'IP Address may not be configured on L2 links'. I have tried the following:
# Config Term
#(C) Interface FastEthernet0
#(C-if) no switch access Vlan 1
#(C-if) ip address 192.168.1.1 255.255.255.0
'IP Address may not be configured on L2 links FastEthernet0
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...