I have a cisco 877 with 3 vlans and and atm interface with a bvi interface.
Vlan 2 and 4 : are nat inside. two different subnets
Vlan 3: bridged directly to atm.
BVI1: nat outside. gets its ip address via dhcp.
I have some static nat port translations from bvi1 to some vlan4 hosts.
Everything works fine. The problem is that when I power cycle the router or the dsl (atm) goes down and then up the nat translations stops working. To work I have to erase the translations and create the again.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...