02-17-2008 05:02 PM - edited 03-03-2019 08:45 PM
Hi,
Can I put cisco 877 in Bridged mode so it can pass the public IP from the ISP to cisco 1811 connected to it?
Internal lan >>(VLAN1)Cisco 1811 (FE1)>>(VLAN1)Cisco 877(ATM0.1)>> PPPoE to ISP
How to configure the dialer interface in 877? How to bridge it to VLAN?
Any info will be much appreciated.
Thanks.
02-18-2008 10:27 AM
Sure.
int atm0 (no need for subinterfaces)
pvc x/y
bridge-group 1
int vlan 1
bridge-group 1
Note in reality the 87 can terminate PPPoE as well. Bewside, where PPPoE is active,most of the time PPPoA works as well.
Hope this helps, please rate post if it does!
no ip address
02-18-2008 02:01 PM
Thank you, it did work.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide