I have a private network on 10.0.5.0, with a Websense server on 10.0.5.20. All client machines on the lan use 10.0.5.20 as the default gateway and dns server. The websense server also has another network card with address 192.168.0.2, and the cisco 877 router has inside address of 192.168.0.1. Will I need to configure an access list to allow traffic from 192.168.0.2(The Websense server) to the internet, or will just the default route suffice?
However, to answer your question. You probably don;t need an access list to allow traffci from the websense server. This will be allowed automatically. What you may need is a static route for traffic on the 10.0.5.0 network point to the websense server.
ip route 10.0.5.0 255.255.255.0 192.168.0.2.
HTH - Pls rate if it does.
A free, open source network device configuration management tool, customizable to your needs!
- Always vote on an answer if you found it helpful
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.