09-29-2009 01:47 AM - edited 03-04-2019 06:12 AM
Hello,
I want to my use Cisco 878 Router as a Bridge and want to make the PPPoE authentication at my different brand firewall. is that possible ?
thanks for your all comments.
09-29-2009 01:48 AM
Yes, just put atm and ethernet inteface in a bridge group.
09-29-2009 02:00 AM
Hi,
please forgive my stupidity,
could you please give me a configuration example about it ?
09-29-2009 02:11 AM
Use the search box top right corner, for that and more.
09-29-2009 03:07 AM
thanks for your fast reply,
when I try to do put fastethernet to bridge-group it says the following message:
HSM(config-if)#bridge-group 1
FastEthernet0 does not support bridging
is it a fixible issue ?
thank you so much.
09-29-2009 03:15 AM
Bridge-group to VLAN1.
09-29-2009 04:02 AM
hi again,
sorry being headacke to you.
now my vlan1 is up bu I couldn't up my atm interface. it says down all the time.
do you have any idea why is that for ?
thanks a lot
09-29-2009 07:00 AM
Check with ISP which service you have contracted and that they have activated it.
09-29-2009 07:27 AM
hi,
thank you for all your advices. it has been very helpful to me. I solved my problem. thank you again.
09-29-2009 07:29 AM
You are welcome, please remember to rate useful posts with the scrollbox below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: