Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 878 Bridge Mode

Hello,

I want to my use Cisco 878 Router as a Bridge and want to make the PPPoE authentication at my different brand firewall. is that possible ?

thanks for your all comments.

9 REPLIES
Hall of Fame Super Gold

Re: Cisco 878 Bridge Mode

Yes, just put atm and ethernet inteface in a bridge group.

New Member

Re: Cisco 878 Bridge Mode

Hi,

please forgive my stupidity,

could you please give me a configuration example about it ?

Hall of Fame Super Gold

Re: Cisco 878 Bridge Mode

Use the search box top right corner, for that and more.

New Member

Re: Cisco 878 Bridge Mode

thanks for your fast reply,

when I try to do put fastethernet to bridge-group it says the following message:

HSM(config-if)#bridge-group 1

FastEthernet0 does not support bridging

is it a fixible issue ?

thank you so much.

Hall of Fame Super Gold

Re: Cisco 878 Bridge Mode

Bridge-group to VLAN1.

New Member

Re: Cisco 878 Bridge Mode

hi again,

sorry being headacke to you.

now my vlan1 is up bu I couldn't up my atm interface. it says down all the time.

do you have any idea why is that for ?

thanks a lot

Hall of Fame Super Gold

Re: Cisco 878 Bridge Mode

Check with ISP which service you have contracted and that they have activated it.

New Member

Re: Cisco 878 Bridge Mode

hi,

thank you for all your advices. it has been very helpful to me. I solved my problem. thank you again.

Hall of Fame Super Gold

Re: Cisco 878 Bridge Mode

You are welcome, please remember to rate useful posts with the scrollbox below.

1499
Views
3
Helpful
9
Replies