I have 2 878 routers that will be getting connected via a BT ESP8 4 wire circut, but the carrier detect led will not come on, I have checked with BT and they are saying that they can only see the TX of the routers at both sides.
I have had to use a RG11 to BT plug adaptor as the routers only came with the RJ11-RJ11 patch lead, and the LTU needs to have a BT plug.
Does anybody know what the pinouts are from the routers, as I can't get the link to come up and need to rule out the cabling.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...