I'm new to Cisco, just got a Cisco 878 Router and want to sort out QoS for my Voip Phones. As i'm new, went to SDM and when I cliked QoS it said i need a IOS upgrade! They market this router as QoS ready and i'm now trying to source this IOS upgrade. Will I need a flash upgrade? Or is there another way to go about this.
Also i have 16 external IP's, can these all be setup as DMZ for the phones?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...