Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 881 with Cellular as primary route, ethernet secondary

Hi, I am currently searching for a method to use an Ethernet interfaces as a backup route to a primary Cellular connection. The catch is that the FastEthernet port needs to enabled/disabled based on Cellular signal strength. Alternatively the Ethernet device attached to the FE has the ability to receive AT commands for connection control. This may be possible with TCL or other methods. If anyone can assist either options or source of TCL information, this will be greatly appreciated.

1 REPLY
New Member

Re: Cisco 881 with Cellular as primary route, ethernet secondary

This was resolved by JClarke - please see Network Management: Cisco 881 with Cellular as primary route, ethernet secondary

102
Views
0
Helpful
1
Replies