Cisco 881GW dynamic failover between WAN and 3G using VPN and NAT
Need help any suggestion are greatly appreciated...
--Desired result: Established an encrypted connection to corporate office (ASA 5520) to support voice and data , while providing dynamic failover
over the 3G cell connection. All traffic must be encrypted.
--Situation: So the orignal router was replaceed with a 881g so we cound have the 3G as a backup connection. The orignal setup used EZVPN as these routers contantly "traveled" to support our team. So as I transfered the config to the new router, I ran into an issue where you can only apply the "Crypto Ipsec ezvpn name outside" command to one interface. My initial thought process was setup both connection and use a floating route to redirect traffic.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...