I'm pretty new to IOS configuration and am having some difficulties mapping some external ports to hosts on the inside of the network.
I have gone through the steps that I expected would work and the hosts on the inside of the network can connect to the outside world and the results of internal to external mappings are present as expected while viewing the debug information.
What is also interesting, as depicted here, is that the static mappings are showing in the transactions table:
tcp 1XX.1XX.1XX.1XX:19770 2YY.2YY.2YY:3389 --- --- These are as configured.
When I attempt to connect to the address using the external port I am not seeing any evidence in the logs that point to the attempted translation being made.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...