Hi there,
I am trying to configure a Cisco 887va router, initially I am trying to get it to route between my adsl connection (ppp over ATM) and my Ethernet lan (only the one default vlan to start with).
Here is my running config:
EVC_R1#sh running-config
Building configuration...
Current configuration : 1965 bytes
!
! Last configuration change at 14:32:46 UTC Wed Jun 11 2014
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname EVC_R1
!
boot-start-marker
boot-end-marker
!
!
enable secret 4 PoXaLzKVosUFI2FS5/CPK/sLYb1wgi0LIF6SRnWhVa2
!
no aaa new-model
memory-size iomem 10
!
!
!
!
!
!
!
!
ip domain name emmaus.local
ip cef
no ipv6 cef
!
!
password encryption aes
license udi pid CISCO887VA-K9 sn FCZ1733C2CL
!
!
username xxx password 0 xxx
username xxx password 0 xxx
!
!
!
!
!
controller VDSL 0
!
ip ssh version 1
!
!
!
!
!
!
!
!
!
interface Ethernet0
ip address 192.168.52.254 255.255.255.0
!
interface ATM0
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
atm vc-per-vp 128
no atm ilmi-keepalive
hold-queue 224 in
pvc 0/38
oam-pvc 0
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
!
interface FastEthernet0
switchport mode trunk
no ip address
!
interface FastEthernet1
no ip address
!
interface FastEthernet2
no ip address
!
interface FastEthernet3
no ip address
!
interface Vlan1
no ip address
!
interface Dialer0
ip address negotiated
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
ip nat outside
ip virtual-reassembly in
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap pap callin
ppp chap hostname xxx@plusdsl.net
ppp chap password 0 xxx
ppp pap sent-username xxx@plusdsl.net password 0 xxx
ppp ipcp dns request
ppp ipcp wins request
hold-queue 224 in
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
ip nat inside source list 1 interface Dialer0 overload
!
access-list 1 permit 192.168.52.0 0.0.0.255
!
!
!
line con 0
password $upp0rt100
login
no modem enable
line aux 0
line vty 0 4
login local
transport input ssh
line vty 5 15
login local
transport input ssh
!
!
end
First off I am aware that the fastethernet interfaces are layer 2 ports on an integrated switch. I assume that ethernet0 should be treated as an actual router port. It seems to support subinterfaces eg ethernet0.1. So what I had envisaged was using fa0/0 as a trunk port and eventually adding vlan router addresses to subinterfaces of ethernet0.
At present my dialer0 interface acquires the correcty ip address from my isp but pings fail to hosts in both my local network 192.168.52.0/24 and to internet hosts. Can anyone look at my config and advise?
thanks very much
Dan
