Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 887VA

Hi guys,

Can someone please post a template for the above router, I am trying to get it connected to my VDSL2 service.

ATM Settings

VPI 0 VCI 38

Encapsulation

PPPoE

Authentication

CHAP

Primary DNS

212.30.8.70

Secondary DNS

212.30.16.251

Protocol

PPPoE

Modulation Type

ITU-T 993.2

Cheers

5 REPLIES
Bronze

Re: Cisco 887VA

Hi,           

I can provide part of it but not the PPPoE. This is for Ethernet access.

controller VDSL 0

firmware filename flash:VA_A_35l_B_35l_23j.bin

interface ATM0

no ip address

no ip redirects

no ip proxy-arp

no atm ilmi-keepalive

interface ATM0.1 point-to-point

ip address 75.x.y.z 255.255.255.252

no ip redirects

no ip proxy-arp

ip virtual-reassembly in

atm route-bridged ip

pvc 0/35

  encapsulation aal5snap

ip route 0.0.0.0 0.0.0.0 75.x.y.v

Re: Cisco 887VA

Bronze

Re: Cisco 887VA

What information has your ISP provided you with regarding configuring VDSL2? For example, they may require VLAN tagging.

This should help get you started:

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf_ps380_TSD_Products_Configuration_Guide_Chapter.html#wp1189826

In particular, note that you do not use ATM settings, these are for configuring ADSL. In fact the ATM interface should be shutdown and the configuration is done via the VDSL controller's Ethernet0 interface.

New Member

Cisco 887VA

Hi guys,

There's no VLAN tagging going on here. I've had a look at the documents, it's not making a lot of sense to be honest. Any chance you could kindly post a templte for me?

Thank you

Bronze

Cisco 887VA

There's a config in this posting:

https://supportforums.cisco.com/message/4083135#4083135

(As you apparently don't need VLAN tagging the subinterface on E0 in this posting is not a necessary step).

432
Views
0
Helpful
5
Replies
CreatePlease to create content