Cisco 888 and 887 LACP and spanning tree support

[e.ciollaro]

Hi everybody,

do 888 and 887  routers (specifically CISCO888-SEC-K9 and C887VA-V-K9) support LACP as Catalyst do ? What I need is to associated a couple of interface of the integrated switching module to a channel-group in LACP passive mode and configure spanning tree cost for those interface. Moreover I have to configure spanning tree priority for their VLAN. May I use the same commands and procedure I use on a Catalyst switch or there is some limitation or difference for the ISR switching module ?

Thanks,

Enrico.

[e.ciollaro]

Find answer by my self: no support for LACP and PAgP on etherswitch in 887.