Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Silver

Cisco 888 and 887 LACP and spanning tree support

Hi everybody,

do 888 and 887  routers (specifically CISCO888-SEC-K9 and C887VA-V-K9) support LACP as Catalyst do ? What I need is to associated a couple of interface of the integrated switching module to a channel-group in LACP passive mode and configure spanning tree cost for those interface. Moreover I have to configure spanning tree priority for their VLAN. May I use the same commands and procedure I use on a Catalyst switch or there is some limitation or difference for the ISR switching module ?

 

Thanks,

Enrico.

 

1 REPLY
Silver

Find answer by my self: no

Find answer by my self: no support for LACP and PAgP on etherswitch in 887.

146
Views
0
Helpful
1
Replies