Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Access Server 2509 IOS Corrupt

hello Guys,

l have cisco access server 2509 and for some reason l think the IOS is corrupt. l try but cannot get in. someone help how to re-installed the IOS again please

thanks

  • WAN Routing and Switching
7 REPLIES

Hi ,  This product is no

Hi , 

 This product is no longer supported . If you have IOS image with you , upload it from Rommon mode 

 

http://www.cisco.com/c/en/us/support/docs/routers/2500-series-routers/15078-recovery-c2500.html

 

HTH

Sandy

New Member

thanksif l turn it on with

thanks

if l turn it on with the rollover cable connected to the pc. it display zigzag characters

and it has not got the button like switch to hold till it takes you to the rommon command line.

Hi From the Using the ROMmon

Hi 

From the Using the ROMmon confreg Utility example above, you see that there are eight possible console baud rates, namely, 9600 (default), 4800, 1200, 2400, 19200, 38400, 57600, and 115200 baud. If you do not know the console speed of the router, it is difficult to set up a hyperterminal session with the correct speed. A solution would be to just try the eight possible console speeds above and see which one works. Another solution would be to open up the box and move a jumper.

 

HTH

Sandy

 

 

New Member

hello Sandycan you see the

hello Sandy

can you see the image of console. so l cannot get into the IOS at all

any idea please

salis

Hi ,  Have you got access to

Hi ,

  Have you got access to console , after changing BAUD rate Speed . 

 

HTH

Sandy

New Member

hellowhen l connect the

hello

when l connect the console to the pc. that is what l see.l am using tera terms, l cannot get into the console even lf l try to issue the break after turning the device on

New Member

hello mr Sandyl have attach

hello mr Sandy

l have attach an image of what l see

85
Views
0
Helpful
7
Replies
This widget could not be displayed.