Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco Aironet 1200 (AP1210)

Folks,

I cannot access this box at all. HyperTerminal shows nothing, I have tried to reset defaults, and still nothing. Defaults to 10.0.0.1? I should then be able to access from browser? I have hyperterminal setup correctly. I am stumped, any ideas appreciated.

1 REPLY
Silver

Re: Cisco Aironet 1200 (AP1210)

By default, the AP requests an IP address through DHCP.However, you can manually set the IP address of the AP. On a Microsoft Windows PC that is connected to the Ethernet segment, from the DOS prompt, issue this command: arp -s a.b.c.d 00-12-34-56-78-90

For more information on the most frequently asked questions (FAQ) about Cisco Aironet Access Points (APs) please click following URL:

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a008009483e.shtml#intro

277
Views
0
Helpful
1
Replies
CreatePlease to create content