I believe the only option that you'll have to do this would be ON. Active/Passive set LACP, but On doesn't specify a protocol and just sets the etherchannel to On. In other words, it doesn't negotiate lacp/pagp but depends on the other side to make a connection. I have IBM servers that are connected to my 6509 and I have the channel groups configured to On.
at the other end I have a switch to "on", but the ASR only gives me the option of "active | passive" I do not want or LAG or LACP and not to negotiate the protocol, so my choice is whether setting "channel-group 1" would be the correct parameter.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.