We have a Cisco ASR 9006 with XR version 4.2.3 and redundant RSP440's. The chassis is full and we are planning to replace a A9K-8T-L with a new A9K-24X10GE-TR. All 8 ports on the A9K-8T-L are configured and in use. Will the existing configuration on the first 8 ports move over to the new A9K-24X10GE-TR or will we need to reconfigure them after the line card is replaced?
Do you already have the A9K-24X10GE-TR line card with you? If you have an active Smartnet contract, you may call Technical Support dept for assistance on the configuration. Feel free to message me for further assistance.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...