I am having a problem with a new ASR1001 we have just installed. We have connected it via single mode fibre to a Cisco 7609, with a /30 IP address. The interface uses MTU 9216 (the max) and is up and working ok. However when we do a ping sweep across the interface it begins dropping packets which are a large size. It never drops small packets, only large ones. Upon investigating further i found the loss starts at size 11465. So pings at size 11464 are fine, 100% success, however 11465 shows 30% packet loss. This level of packet loss does not rise the larger the size of the ping it stays about the same. The packets drop completely randomly, no pattern, sometimes 10 work in a row, sometimes 10 fail, sometimes its mixed. I am at a loss as to what could be causing this, anyone have any suggestions?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...