Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco ASR9K6 strange message under sh redundancy

Dear All,

have anybody ever seen this failure message after using the "show redundancy" command ? (marked in red)                  

Before it happened the RSP1 was lost for 30h.

Datum Bemerkung Errichtet am Errichtet von Errichtet um

Reload and boot info 06.11.13 ASIEBENB 13:18:48

---------------------- 06.11.13 ASIEBENB 13:18:48

A9K-RSP-4G reloaded Sat Nov  2 16:32:41 2013: 3 days, 20 hours, 43 minutes ago 06.11.13 ASIEBENB 13:18:48

Active node booted Sun Nov  3 15:09:33 2013: 2 days, 22 hours, 6 minutes ago 06.11.13 ASIEBENB 13:18:48

Last switch-over Wed Nov  6 13:10:10 2013: 5 minutes ago 06.11.13 ASIEBENB 13:18:48

Standby node boot Wed Nov  6 13:11:00 2013: 5 minutes ago 06.11.13 ASIEBENB 13:18:48

Standby node last went not ready Wed Nov  6 13:15:57 2013:  9 seconds ago 06.11.13 ASIEBENB 13:18:48

Standby node last went ready Wed Nov  6 13:15:57 2013:  9 seconds ago 06.11.13 ASIEBENB 13:18:48

There has been 1 switch-over since reload 06.11.13 ASIEBENB 13:18:48

  06.11.13 ASIEBENB 13:18:48

Active node reload "Bus Transfer Error (TEA)" 06.11.13 ASIEBENB 13:18:48

Standby node reload "Cause: Initiating switch-over." 06.11.13 ASIEBENB 13:18:48

Datum Bemerkung Errichtet am Errichtet von Errichtet um

Reload and boot info 06.11.13 ASIEBENB 13:18:48

Regards

Andreas

Everyone's tags (4)
136
Views
0
Helpful
0
Replies