Dear all,
Cisco has proposed to us the new router reference C888-K9.
It has a WAN interface supporting ATM/EFM technologies using one pair, two pairs and even four pairs.
We tested with a 4 pairs EFM circuit and it works perfectly, however with a 4 pairs ATM circuit we cannot bring UP the router.
Is it a special configuration to use a 4 pairs ATM circuit?
I don't have the IMA option on dsl-group, only m-pair is shown, can it be the cause of the issue?
Thanks for your help,
Kind regards,
Camilo Ramirez
Support MyStream