Cisco command for junos command "set community members bandwidth
The "set community members" is used inside a policy statement. Most likely to match on a specific community configured that has been under the label "bandwidth". In the IOS world, a route-map is more or less equivalent to a policy statement. We would need the entire policy statement in order to tell you what the equivalent route-map would look like.
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) firstname.lastname@example.org México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...