If your Cisco devices do not fully support EIGRP then OSPF might be a good choice of dynamic routing protocol for you to run. And depending on your circumstances it might also be a satisfactory solution to run RIP or RIPv2.
I know that there are some Cisco layer 3 switches or feature sets on those switches that support EIGRP stub routing but not the full implementation of EIGRP. I was not aware that this was true of the 6500.
If your 6500 does not support the full implementation of EIGRP it may be a restriction of the particular release and feature set that you are running. I know that it is not a restriction of the 6500 itself. I have customers running 6500 switches that are running full feature EIGRP on those 6500 switches.
Perhaps you can post details of the version and feature set of the code that you are running?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.