Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco E1 interface configuration

Hello everyone,

 

I have a router with 2 E1 interfaces, and just aded a 3rd. How can i configure the 3rd interface so that it only recives calls? I need out bount calls to always go thorught either the first and 2nd interface and not the 3rd. Is this configuration going to be made on the interface? voice-port? Dial-peer?

 

 

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

You should use trunk-groups

You should use trunk-groups with dial-peers config...more on:

http://www.cisco.com/c/en/us/td/docs/ios/12_2/dial/configuration/guide/fdial_c/dafntpri.html#wp1024553

 

HTH,

Dragan

HTH, Dragan
2 REPLIES
Silver

You should use trunk-groups

You should use trunk-groups with dial-peers config...more on:

http://www.cisco.com/c/en/us/td/docs/ios/12_2/dial/configuration/guide/fdial_c/dafntpri.html#wp1024553

 

HTH,

Dragan

HTH, Dragan
New Member

Thanks for the response! I

Thanks for the response!

 

I ended up finding a simple solution. I deleted the outgoing call-leg. Will try to implement trunk-groups later though! I think it will help distribuite calls evenly btweeen the interfaces. 

52
Views
0
Helpful
2
Replies
CreatePlease to create content