I am trying to build my own CCNP lab. I have found some used Cisco 2651XM router that is not used any more in production. I think that it would be just fine for learning. I have a problem. When the IOS is loaded i start getting this error: %AMDP2_FE-3-UNDERFLO: FastEthernet0/1 transmit error.
This error starts to show after IOS loads. Please take a look at attachment (PNG picture, screenshot).
There is no starup-configuration and there is nothing connected (except console cable).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...