I had my Cisco ISA550w configured with Advanced NAT so that we could access an internally hosted webserver using the external domain name. I (like a dummy) made some changes to the WAN interfaces and all the NAT configurations went byby. I know can no longer get it to work. I am sure I am just not setting up the NAT rules correctly, but I am about to toss the thing into the patomac. Anyone out there have this setup on an ISA or know how to do it. The KB is literally no help. Thanks in advace for any help and or assistance.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...