Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco Lab setup

I am trying to setup 2 routers Lab.

Routers: 2501 and 2524.

Q. How do I connect these two routers by

cables. I have one transcevier only.

one rollover R45 cable. I have

configure both the routers. But don't

know how to connect these and make CNA lab.

4 REPLIES
Silver

Re: Cisco Lab setup

Hello,

You have two options:

1- The easiest is to get serial Cables and connect the routers back to back. You will need to set the clock on the DCE side of the cable. You will need one V.35 Serial Male Cable and another V.35 Female cable.

2- Terminate the two routers serially to two NTUs and connect the NTUs using RJ-45 cable to each others thus simulating a leased line betyween the router. Therefore, you need to NTUs with two serial cables.

Hope this helps and appreciate your rating,

Regards,

New Member

Re: Cisco Lab setup

Thanks

New Member

Re: Cisco Lab setup

hi, do not waste your time with that.

use this: http://www.dynagen.org/tutorial.htm

or even better GNS3

serg

New Member

Re: Cisco Lab setup

Yes I am doing Dynamips also. Thanks

219
Views
0
Helpful
4
Replies
CreatePlease to create content