Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco PIX 515E Natting

I am trying to enable Natting on a new Cisco PIX Firewall 515E but I have not managed. I have enabled both interface0 and interface1 but when I connect a cable from my Satellite modem on the ethernet0, there seem not to be any activity. I think I have configured all the IP addresses correctly but I can't manage to connect to the internet. I don't know how to get the PIX to use the gateway and route traffic from my inside net to the internet. I tried to used ASDM but when I loggin it says page can not be found and does not load the application.

Is this normal? Is there something I can do to enable Natting and connect to the net? I have managed to get the DHCP server working but that's as far as I have gone.

Philip.

2 REPLIES

Re: Cisco PIX 515E Natting

Try adding this.

nat (inside) 1

global (outside) 1 interface

route outside 0.0.0.0 0.0.0.0

HTH

Sundar

Silver

Re: Cisco PIX 515E Natting

interface gb-ethernet0 1000auto

interface gb-ethernet1 1000auto

ip address outside

ip address inside

global (outside) 1 204.69.198.254

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

route outside 0.0.0.0 0.0.0.0 {Next hop IP address}

access-list 100 permit tcp any any

access-list 100 permit ip any any

access-group 100 in interface outside

If you have 7.X IOS ... than great to easy configure looks like Router.

Enjoy... Have a Best Week End.

Regards,

Dharmesh Purohit

86
Views
0
Helpful
2
Replies