Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco Route map question

I already have a route-map in place allowing traffic from 192.168.101.0/24 to use dual ISP, tracked using SLA.

I want a host behind to have a specific public IP, so I can connect too either public IP if one ISP fails.  I was thinking something like this but not sure how I speficify the specific public IP on each VLAN.

Do I need to "match interface" to an IP or something?

Access-list 200 permit ip 192.168.101.200 0.0.0.255 any

route-map CCTV_ISP1 permit 10

match ip address 200

match interface vlan3

route-map CCYV_ISP2 permit 10

match ip address 200

match interface vlan2

ip nat inside source route-map CCTV_ISP1 interface Vlan2 overload

ip nat inside source route-map CCTV_ISP2 interface Vlan3 overload

normally if a single IP a static NAT

ip nat inside source static tcp 192.168.101.4 1723 x.x.x.x 8080 extendable if what I'm trying to replicate but allowing mapping from both when failover occurs

Everyone's tags (1)
1 REPLY
Purple

Cisco Route map question

Hi,

just do another entry like this with the other public IP or external interface:

ip nat inside source static tcp 192.168.101.4 1723 x.x.x.x 8080 extendable

Regards.

Alain.

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
171
Views
0
Helpful
1
Replies
CreatePlease to create content