Data: Video from the branches will be sent to the Main Office(streaming)
The estimated speed of IPVPN Connections at the Head Office is 90Mbps and at the Branch is 2Mbps but there is a possibility that the speed will increase in a future.Is Cisco 1921 is enough for Branch stations? Or should I go to 1921? What cisco router model can cater the estimated 90mbps IPVPN WAN Speed?
Can the 2900 series can support the 90mbps or we will go for 3900 series?
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
The attachment provides both Cisco's bandwidth support recommendations for most ISRs and their tested peformance under different usage situations.
For 90 Mbps, the 3925 should be about right. For 2 Mbps, the 800 series should do. However, depending on projected growth, vs. expected device life cycle, you might, as Leo suggests, buy larger. How much larger depends on your expected growth in bandwidth usage.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...