I've looked at the RPS-2300 documentation and have a couple of questions with regard to its use.
If connected to a router (2851) and the power/PSU fail the RPS-2300 unit will support the router. However when the normal power is replaced the documentation says that the router may reboot - is this the case.......
Also I have a question with management of the device does it have to be connected to a 3750-E/3560-E switch or is it able to have a IP address to connect to.
If anyone has used these in anger and can pass on any more info it would be appreciated.
I'm interesting in managing possibilities. I know that we can manage RPS through Cisco CNA, but is it possible to manage RPS through IOS CLI? I found command show rps in Command-Line Reference for 2900XL/3500XL, but unfortunately Cisco Command Lookup Tool doesn't know this command. Any ideas? Thx for help!
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...