Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco SB101 with SNMP

Ok, I am very new to routers. I am trying to enable the SNMP through the SDM utility, but there is little information in the screens on to what the best route is for this. I am trying to get the information off the router to a network monitoring utility.

Thanks,

1 REPLY
Silver

Re: Cisco SB101 with SNMP

Because SDM uses a default configuration file, if you have used SDM to configure your router, it does not execute the standard Cisco IOS startup sequence.

115
Views
0
Helpful
1
Replies
CreatePlease to create content