Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Speak cmd

It has been a while since I have used it. But thier was an IOS cmd where you could send a note to any users in the router. Does anyone know the command. I thought that it was cisco# speak and then the note but that doesn't seem to be working for me. Any help I will rate.

4 REPLIES
New Member

Re: Cisco Speak cmd

Hi,

what platform are you using? do you mean a banner motd?

config t

(config)#banner motd # Use strictly prohibited #

Regards

Peter

Hall of Fame Super Silver

Re: Cisco Speak cmd

Josh

You got the first letter right. Check out "send" instead of "speak". Send is used to send messages to other users on the router.

HTH

Rick

Hall of Fame Super Blue

Re: Cisco Speak cmd

The command is "send"

HTH

New Member

Re: Cisco Speak cmd

Is it "send" which u r looking for???

Router#send ?

* All tty lines

<0-81> Send a message to a specific line

aux Auxiliary line

console Primary terminal line

qdm Send a message to QDM client

tty Terminal controller

vty Virtual terminal

Router#send *

Enter message, end with CTRL/Z; abort with CTRL/C:

hello ^Z

Send message? [confirm]

Router#

***

***

*** Message from tty0 to all terminals:

***

hello

Router#

If this is not what you are looking for , can you tell me what you meant by any users in the router??????

Thanks,

Pallavi

194
Views
0
Helpful
4
Replies
CreatePlease to create content