I have 4- Catalyst 4500 switches and I need to know if there is a way that I can see the computer names that are connected to each port. I know that I can see the other Cisco devices, but I want to know if there is a way that I can pull the computer name from each computer....the guy that hooked things up before me just pluged things in where ever he could find an open slot....so there are cables all over the place...what I want to do is divde the floor up into areas and connect them to each switch that I setup for each area of the floor....
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...