cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
528
Views
0
Helpful
1
Replies

Cisco WAN LAB

juan-ruiz
Level 1
Level 1

I have two Cisco routers with two integrated T1 CSU/DSU. I would like to connect them between each other to simulate a WAN but not sure how.

I have used a cross over cable with special pin out for internal CSU/DSU but that does not seem to work.

If someone can provide a clue I would really appreicate it.

Thanks,

Juan 

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

That is so often asked, that if you search this forum or the internet, you will find plenty of discussion on the matter.

View solution in original post

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

That is so often asked, that if you search this forum or the internet, you will find plenty of discussion on the matter.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco