Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco1841 and WIC-1B-S/T unknow card

hallo, we have purchased new cisco1041 isr and ISDN WIC-1B-S/T cards.

The ios onboard is 12.4(1a) IP BASE.

The router does not recognise the WIC-1B-S/T card !

Here the message:

"%CFG-3-CARD_NOT_SUPPORTED: Slot 1: BRI S/T - 2186 WAN daughter card, Part#80-1833-5, HW-Rev 1.3, Board-Rev B0, S/N 33503975"

I receaved the end-of-life announcement for WIC-1B-S/T on 4-12-05 by email.

I need to be sure that this wan card is not supported by cisco1841 and that it is not an ios bug.

Is there a workaround ?

Must I use only the new card WIC-1B-S/T-V3 ?

The same problem is there on cisco2800 too ?

best regards

Francesco Soffia

2 REPLIES

Re: cisco1841 and WIC-1B-S/T unknow card

Hi

As per the datasheets aval both 1800 and 2800 supports only following ISDN BRI WICs.

WIC-1B-U-V2 1-port ISDN BRI with integrated NT1 (U interface)

WIC-1B-S/T-V3 1-port ISDN BRI with S/T interface

http://cisco.com/en/US/products/ps5853/products_data_sheet0900aecd8016a59b.html

http://cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8016fa68.html

regds

Re: cisco1841 and WIC-1B-S/T unknow card

Francesco,

You need the v3 S/T wics. With the newer revisions in mobo from Cisco on the 1800s/2800s/3800s the older cards will not work on this router. (V1 ISDN and T1 wics)

1097
Views
0
Helpful
2
Replies
CreatePlease login to create content