Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Cisco2811 with ADSL

Hi,

I have Cisco 2811 router with WIC-1ADSL card, when i issue show diag, i can't see the card at the installed slot. So, i upgraded the IOS to one that supports ADSL, after that when i issue the show diag i see the following:

WIC Slot 1:

E1 Drop&Insert & G.703 (2 port) WAN daughter card

Unknown EEPROM ver 67

EEPROM format version 67

EEPROM contents (hex):

0x20: 43 30 00 00 05 C1 4F 43 33 39 53 50 81 00 00 04

0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

Is it hardware failure at the card? or what?

Thanks in advance

Abd Alqader

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Cisco2811 with ADSL

Yes, it seems at minimum the eeprom got corrupted. The card should be replaced.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: Cisco2811 with ADSL

Yes, it seems at minimum the eeprom got corrupted. The card should be replaced.

Hope this helps, please rate post if it does!

225
Views
0
Helpful
1
Replies
CreatePlease to create content