Ciscoworks LMS 2.6 - is not discovering 1 device on our network. It is able to discover a similar device on the same subnet with the same community strings. Why is it unable to discover this 1 particular device? Thanks.
Hi , I had similar problems with Cisco Work discovering switches in Panama, I was able to fix it by checking and changing the discovery settings. I change the HOP limit and confrim that all of our subnets were listed in the Filter Settings, is the unit in question reachable from your Seed device? it should be. You can go to Device Center and do a SNMP walk to the IP address of the device if it fails you might consider added it manually. HTH
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...