Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

clear arp table

we are switching over new server Domain Controller cards

What is the best way to clear the arp table?

I do a show ip arp..and a table of

IP's and macs.

I issue a clear arp command..but the

table reamins

I issue a clear-arp cache command..but the table remains?

Also what about the clear ip arp command?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: clear arp table

Richard

I checked on a router and there is a single command clear arp-cache. So you can execute clear arp and it works (because arp is an abreviation of arp-cache) and of course you can do clear arp-cache. When I try to put a space inbetween arp and cache clear arp cache I get an error for invalid syntax.

HTH

Rick

8 REPLIES
Blue

Re: clear arp table

What platform and version of IOS are you running?

Re: clear arp table

Hi Richard,

When you did a "clear arp-cache" command. Is that host(Existing AD) still alive? Are there any connections to that host? Please follow these steps.

http://www.cisco.com/en/US/docs/ios/ipaddr/configuration/guide/iad_cfg_arp_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1096656

HTH,

Toshi

Community Member

Re: clear arp table

Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(25)SEE2, REL

ASE SOFTWARE (fc1)

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Hall of Fame Super Gold

Re: clear arp table

Richard

It can be a bit confusing about clear arp because as you state in your original post it appears that the arp table is still there. But if you look carefully you will see that this is not really the case. When you issue the clear arp command the Cisco will purge the entries in its arp table and it will immediately issue arp requests for every address that was in the table. Assuming that the same devices are still alive on the network then they will all respond and a table will be built that looks like the original table. But if some device has powered down then its entry will disappear from the arp table. And if a device has a different NIC then its IP will still be in the table but it will have a different MAC (if you look carefully you can see these differences, but to casual observation the table looks just the same).

HTH

Rick

Re: clear arp table

Rick,

I can't explain in that way.

5P!

Thanks

Toshi

Community Member

Re: clear arp table

great! thx..

is there a diff in the clear arp

and clear arp cache command?

Hall of Fame Super Gold

Re: clear arp table

Richard

I checked on a router and there is a single command clear arp-cache. So you can execute clear arp and it works (because arp is an abreviation of arp-cache) and of course you can do clear arp-cache. When I try to put a space inbetween arp and cache clear arp cache I get an error for invalid syntax.

HTH

Rick

Community Member

Re: clear arp table

great thx..

sometimes the obvious answers are the easiest ones :-)

2384
Views
5
Helpful
8
Replies
CreatePlease to create content