Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

clear policy-map counters

Hi

Can Everybody tell me how can I clear the counters of the policy-map statistics in an 7600 and the 1841 router?

thanks

8 REPLIES
Cisco Employee

Re: clear policy-map counters

clear counters FastEthernet0/1 (or any other interface)

New Member

Re: clear policy-map counters

hi Greg.

but that command doesnt clear the drops stadistics? tks

Cisco Employee

Re: clear policy-map counters

It should, what IOS are you running? Send me the output of sh policy-map int before and after clearing the counters.

New Member

Re: clear policy-map counters

You could bounced the qos policy config...take it out and put it back in.

New Member

Re: clear policy-map counters

Hi,

Ran accross this too,

Routeur wouldn't clear the policy-map counters (sh policy-map int xx) when clearing the specific interface...

Try clearing counters for all interfaces, worked for me..

ie:

clear counters

!## Make sure you hit enter to confirm at this prompt : Clear "show interface" counters on all interfaces [confirm]

Good Luck

New Member

clear policy-map counters

Hi,

On my Cisco 2821 I used the following to clear the Service Policy counters on the Multilink interface.

clear counters mu1

or

clear counters multilink 1

Hopes this helps.

Chad

New Member

clear qos counters int

clear qos counters int XXXXBLA.BLA.BLA (as an example)

New Member

My prior response is on a 9K

My prior response is on a 9K

16338
Views
8
Helpful
8
Replies