Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Clear unknown protocol drops

If I do clear counters or clear counters fa0/0...it clears every stat except unknown protocol drops...(see below)...how do I clear that stat?

FastEthernet0/0 is up, line protocol is up

Hardware is MV96340 Ethernet, address is 001a.2f52.49f0 (bia 001a.2f52.49f0)

Description: ;;SUBSCRIBER GATEWAY;;MR;L3 FE;

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s, 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:07, output 00:00:00, output hang never

Last clearing of "show interface" counters 00:00:42

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 90000 bits/sec, 63 packets/sec

5 minute output rate 241000 bits/sec, 39 packets/sec

1346 packets input, 353605 bytes

Received 240 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog

0 input packets with dribble condition detected

854 packets output, 274919 bytes, 0 underruns

0 output errors, 0 collisions, 2 interface resets

4415151 unknown protocol drops

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

1 REPLY
Hall of Fame Super Gold

Re: Clear unknown protocol drops

Woops, seems like you've met one of these things that cisco "forget" to handle right, and only a reload can clear.

579
Views
0
Helpful
1
Replies