I am planning to upgrade one of the data center spine switch Nexus 7000.
Cisco says to remove inactive ACL
But in my configuration, the command shows inactive ACL configuration which are applied on the SVI (e.g. see below) I am not sure why they are inactive. is this due to the bug CSCtf36357 n7k: Need ability to configure ingress netflow sampling with dhcp relay... but i am confused what will happen if I clear the inactive config..certainly I dont want to remove all my acls from the switch
gw01-vdc01(config-if)# sh running-config aclmgr inactive-if-config
!Command: show running-config aclmgr inactive-if-config !Time: Wed Aug 20 10:49:54 2014
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.