Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Clocking Multilink T1s

Hi,

I have following config on two routers; one set for internal and other as line for clocking.

Interface serial 0/0/0

service-module t1 clock source line/internal

service-module t1 timeslots 1-24 speed 64

service-module t1 framing esf

service-module t1 linecode b8zs

If I add another T1 and do the multilink, should I still configure cloking on each interface. Or is there any "global" clocking config for both t1 links.

TIA,

2 REPLIES
Hall of Fame Super Bronze

Re: Clocking Multilink T1s

All service-module commands will go to each interface.

Hall of Fame Super Gold

Re: Clocking Multilink T1s

Note, that if there is an actual T1 circuit between routers, both sides should clock to line.

189
Views
0
Helpful
2
Replies