I've never mixed data T1s and PRIs on the same WIC card before. My setup is this: 2 VWIC2-2MFT-T1/E1 cards. On Card 1, I will have 1 PRI and 1 Point-to-Point data T-1. The second VWIC will have 2 T-1s in a Bonded MLPPP MPLS circuit. All cards are in the motherboard WIC slots. The PRI gets clock source from the line and the MPLS Circuits if they were by themselves would be set to that as well. The PTP circuit can be configured either line or internal if need be. The provider doesn't clock the circuit and I have control of the other end.
Please advise the best way to set this up. Clock source indepedent was brought up but doesn't seem like it will work based on my attempt to configure it already.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...