Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

CMCC-3-PLIM_STATUS

Background:

ASR1002 with ASR1002-SIP10 - started receiving PLIM status messages

%CMCC-3-PLIM_STATUS: SIP0: cmcc:  A PLIM driver informational error SPA1 L2 protocol field offset past packet EOP, block 1b count c

Any insight would be helpful, these error messages have occured 6 times in the last 24hrs and I am aware of the error message and recommended action which is not insightful.

Error Message    %CMCC-3-PLIM_STATUS : A PLIM driver informational error [chars], param 
block[hex] param count[hex]

Explanation    A physical layer interface module (PLIM) HyperTransport (HT) driver I/O has failed.  This error could be caused by a hardware defect or an HT driver defect.

Recommended Action    Examine the logs for PLIM or hardware errors.

Mike

1161
Views
0
Helpful
0
Replies
CreatePlease to create content