Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

cmts init(io)

Is anyone familiar with the cable modem state of "init(io)", as reported by a Cisco CMTS?

4 REPLIES
Community Member

Re: cmts init(io)

I don't know init(io), but i know init (o) which means that cable modem request a config file to CMTS.

Which kind of cmts do you have ?

please, rate this post.

Community Member

Re: cmts init(io)

10012 UBR

Community Member

Re: cmts init(io)

If you cable stay in init(O), you have to verify your config-file.Make sure that after init(d) state (dhcp for getting ip address), the cable modem can communicate with CMTS.

If it is not goog, send me the config file , the dhcp pool of the cable modem and interface cable configuration.

Regards.

Community Member

Re: cmts init(io)

Hi Brian,

Try the link below. It explains all the stages that a modem go though during startup process:

http://www.cisco.com/en/US/partner/tech/tk86/tk89/technologies_tech_note09186a0080094eb1.shtml

Let me know if this helps.

Cheers

Vivek

4719
Views
0
Helpful
4
Replies
CreatePlease to create content