02-22-2006 09:33 AM - edited 03-03-2019 11:49 AM
Is anyone familiar with the cable modem state of "init(io)", as reported by a Cisco CMTS?
02-22-2006 11:29 PM
I don't know init(io), but i know init (o) which means that cable modem request a config file to CMTS.
Which kind of cmts do you have ?
please, rate this post.
02-22-2006 11:42 PM
10012 UBR
02-23-2006 02:28 AM
If you cable stay in init(O), you have to verify your config-file.Make sure that after init(d) state (dhcp for getting ip address), the cable modem can communicate with CMTS.
If it is not goog, send me the config file , the dhcp pool of the cable modem and interface cable configuration.
Regards.
10-26-2006 09:29 PM
Hi Brian,
Try the link below. It explains all the stages that a modem go though during startup process:
http://www.cisco.com/en/US/partner/tech/tk86/tk89/technologies_tech_note09186a0080094eb1.shtml
Let me know if this helps.
Cheers
Vivek
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: